GE Logiq 7 Spare Part Repair | 5118606 P01769P1

SSR PCB (Scan Switch & Relay Board) –GE Logiq 7 Ultrasound System / GE Logiq 7-P01769P1

Typical Fault Symptoms

• Machine stuck on POST (Power-On Self-Test)
• Probe not detected or cannot switch probes
• Channel loss or image artifact
• System reports communication error with SSR board
• Error code P01769P1 appears

Common Fault Causes

• SSR board 5118606 damaged (relay failure, chip fault, cold solder)
• Loose or corroded cable connections
• Unstable power supply to front-end module
• FE-BE communication failure
• Software configuration or firmware error

Repair & Replacement Service

• Replacement of tested good 5118606 board
• SSR board component level repair (relay / IC / solder)
• Troubleshooting for P01769P1 error
• System calibration and stability test after repair